Fallout 3 Case Mod by Dewayne Carel
The two small gauge that I got are going to be placed into the ROM drive bay area so I need something to hold them there. I grabbed some metal, made a plate to the length I needed, added some notches to where it needs to bend to fit into the bay.
A couple of clamps and a small piece of angle iron were used to bend the metal right where it needed to be bent.
I wanted to give this panel more detail so I added a second plate that will rest behind the gauges
Here who it came out
Calling it good for now and I will done some finishing work later as I have a lot to do.
Next I moved to the side panel to layout and install the gauges for test fitting and stuff as I still had work to do on them. I wanted a raised part like I did no the front so some aluminum was cut to fit.
Holes where drilled for the gauges and knobs. Some of these knows will be switched out as I did not like the way they looked
What case did you use?
Thermaltake s41 Urban